ATC PH Meter Pen for Fresh & Salt Water Aquarium

1080

  • Measurement: pH 0.0 to 14.0 pH
  • ATC Temperature: 0.0 to 50*C ( 32 to 122*F)
  • Resolution: pH 0.1
  • Accuracy: pH +/- 0.1
  • Calibration: Calibrated by factory(manual 1point)

Out of stock

Description

Important-The instrument’s PH range Must be re- calibrated whenever. the electrode has been used (laid)for long time from the last calibration.the electrode has been used in particularly taxing conditions. the utmost accuracy is required. Battery install- if the display of meter fades, to replace all the batteries. pull out the battery case and replace the batteries.pay attention to the polarity of battery. specification- range-0.0~14.0ph resolution-0.1ph accuracy-0.1ph Temperature compensation- 0 degree C~ 50degree C Battery-4×1.5V(LR-44) Operating Temperature-0degreeC~5degreeC Dimensions-150mmx29mmx20mm weight-51g OPERATION • Remove the protective cap. Do not be alarmed if white crystals appear around the cap. This is normal with pH electrodes and they dissolve when rinsed with water. • Turn the meter on sliding the switch on the top. • Immerse into solution up to the max immersion level. • Stir gently and wait until the display stabilizes. Readings are automatically compensated for temperature variations. • After use, switch off pH meter, use the water clean the electrode and replace the protective cap. DO NOT USE DISTILLED OR DEIONIZED WATER FOR STORAGE PURPOSES. • Large fluctuations in readings could be due to lack of calibration, dry electrode or rundown batteries. CALIBRATION • Immerse the tester up to the maximum immersion level in pH 6.86 buffer solution • Allow the reading to stabilize and using a small screwdriver adjust the calibration trimmer to read 6.9. Calibration is now complete. ALWAYS USE FRESH BUFFERS FOR CALIBRATION. BATTERY REPLACEMENT When the meter cannot be switched on or the display fades, pull out the battery compartment and replace all three 1.5V batteries, while paying attention to their polarity. Batteries should only be replaced in a safe area using the battery type specified in this instruction manual.

Reviews

There are no reviews yet.

Be the first to review “ATC PH Meter Pen for Fresh & Salt Water Aquarium”

Your email address will not be published. Required fields are marked *